Home Maintenance – Dryer

If you have a dryer with a duct that constantly gets clogged by lint, a number of issues could be the cause. For instance, a flexible plastic duct is a notorious lint trapper and is actually designed for attachment to bathroom fans. If your duct is made of this material, swap it out for aluminum dryer duct instead and avoid a fire hazard.

Poor routing also adds to the problem Dryer Repair Los Angeles. Bends cause friction which creates resistance to the dryer’s exhaust stream. Avoid 90-dcgree elbows which are akin to adding 5-ft of duct. Because of building codes, keep the length at 25ft. max when straight; shorten this when taking into account friction causing bends and elbows.

Be sure to inspect the cap located at the end of the dryer duct as clogs here will restrict air flow and cause blockages. By sealing the vent cap with copper mesh or sheet aluminum you can keep rodents from nesting inside a poorly fitted vent cap.

Ultimately, for keeping a dryer vent clear nothing beats minimizing lint altogether. Avoid overloading the dryer as the friction created by clothes rubbing together produces lint. Reducing load size, therefore, minimizes friction. Use fabric softener which will reduce shedding and enough detergent to allow for lint to be rinsed away in the wash cycle.

Home maintenance calls for us to be ever vigilant on potential issues to avoid costly repairs. An area which you can do this is with the bathroom’s most important fixture – the toilet. If the toilet begins to make noises or to vibrate after flushing look for the following causes:

1. Since the toilet used to function normally, you can be sure that something has worn out or become maladjusted. This problem may be caused when water supplied through the stop-valve fixture is either reduced or increased. Be sure that no one has messed with this valve.

2. A water-pressure reducing valve may be out of sync or may need to be rebuilt. This can only be possible if the house uses municipal water.

3. A water hammer arrestor can malfunction becoming waterlogged. If the arrestor you have relies on an air pocket only to cushion pressurized water, you’ll have to replace it when it becomes waterlogged, unlike pressurized arrestors that can be changed.

Leave a Reply

Your email address will not be published. Required fields are marked *